Link ECU G4X SupraLink TS2JZX PlugIn fits Toyota Supra 2JZ non VVTi Manual Transmission only

Link ECU G4X SupraLink TS2JZX PlugIn fits Toyota Supra 2JZ non VVT Manual Transmission only

SUPRALINK – TS2JZX

Easy to install. Affordable. Reliable.

G4X PlugIn ECUs offer the latest in engine management technology, designed to easily maximize the potential from your car.

This ECU fits inside the factory OEM enclosure. Installation is a breeze, with no alteration of the factory wiring loom required for the models listed below.

Designed for the2JZ non VVTi engine.

• Please check your connector matches the header in the listed photo before purchasing.
• This ECU works for manual transmissions only.
• No onboard MAP sensor.
• XS Loom & map sensor highly recommended.
• Most factory features are supported.
• Check the features tab for I/O expansion options

Suitable applications:

Toyota Supra 2JZ non VVTi

This ECU will support naturally aspirated, parallel twin or single turbo configurations. Does not support sequential control of the stock twin turbos (note: does not fit case of the NA supra)

G4X PlugIn Key Features (where applicable):

Up to 6D fuel and ignition mapping

Precision closed loop cam control (four cam, independent control)

Sequential fuel delivery

Digital triggering, all OEM patterns

OEM idle hardware supported

5D boost control with three switchable tables

Motorsport features – antilag, launch, flat shift

Continuous barometric correction (on board)

CAN port

QuickTune – automated fuel tuning

Individual cylinder correction

USB tuning cable included

Stats recording into on-board memory

Gear compensations for spark, boost and fuel

Real time selectable dual fuel, ignition and boost maps

Sync and crank sensors can be a combination of Hall effect, variable reluctance or optical

Boost control referenced to gear, speed or throttle position

512 mega bytes data logging memory

Staged injection

Knock with “windowing”

I/O Expansion Options

The Toyota Supra plug-in ECU has two expansion connectors.

From PCB revision 1.2:

Expansion Connector 1::

Gnd Sensor Ground Only

+5V Out Low Current +5V Supply

An Volt 7 Analog 0-5V input

An Volt 6 Analog 0-5V input

An Temp 4 Temperature sensor input

An Temp 3 Temperature sensor input

DI 8 Digital input

DI 7 Digital input

Expansion Connector 2

Gnd Sensor Ground Only

+5V Out Low Current +5V Supply

Aux 9 EThrottle – can’t be used as an Aux Out

DI 9 Digital input

DI 10 Digital input

An Volt 8 Analog 0-5V input

An Volt 9 Analog 0-5V input

An Volt 10 Analog 0-5V input